The REC-CN658 is an open jaw version of the REC-658U latched-type tool. The open jaw can easily fit into tight situations where the closing of a jaw latch would be a problem. The jaw is covered with a rubber boot designed to provide some insulated protection against “brush” contact with energized cables. The tool should not be used as an insulated tool since the dies and die holding pins are always exposed.

The head can be turned 180° and positioned to accommodate the operator’s work methods. A complete cycled compression is accomplished by the simple squeeze of a trigger. A factory preset by-pass cartridge assures a complete compression every time. Its 6-ton output is equal to any comparable handheld, hydraulic compression tool and far exceeds any mechanical crimper. The REC-CN658 is supplied with D3 nest dies, which can be interchanged with Kearney, or T&B “O” type dies. If you wish to use the Huskie or another brand of “W” type dies, simply slide them over the D3 nest dies and snap in position. The output pressure, of the REC-CN658 can be checked with the PG-15 pressure gauge when necessary.

Product Information

Part Number: REC-CN658
Product Type: 6 Series, Crimping tools
Related Industries: Distribution, Electric utilities, Mining, Substation, Transmission, Windfarms

Tonnage: 6 ton
Jaw opening: .95"
Weight: 10.7 lbs. with Battery
Size: 16”L x 10”H x 3.1”W
Operation: Battery powered

REC-CN658: Tool Breakdown
REC-CN658: Manual and Tool Breakdown
REC-CN658: Tool Facts


Materials: Aluminum, Copper, H-Taps
Range
H-Taps up to 4/0-4/0
Lugs up to #8-300 MCM Al
Lugs up to #8-500 MCM Cu
Splices up to #8-300 MCM Al
Splices up to #8-500 MCM Cu

Due to material composition, the ratings are to be used as a guide. For questions regarding a specific material, please contact a Huskie Tools Representative.


Get a QuoteGet a quote from your local Huskie Tools Representative

Related products